Service manual

6-8
CD-S500 Series
6-5 Demonstration Printing Function
If FEED switch is held down while the printer is turned on with the front and rear covers closed, the
demonstration printing mode is started. Then “demonstration patterns and the setting of the software
switch” are printed. After completing the printing, the printer shifts to normal power-on status
through POWER ON RESET operation.
FROM VER. CQ01-XXXX
FROM DATE -MM/DD YY
Impact Dot Printer
CD-S500
Feature:
Print Speed: Approx. 5.0 lps
Paper-drop-in style (40 col.)
Logic Seeking Control
Selectable Paper Width
(76.2/69.5/57.5 mm)
Two Color Printing (Red/Black)
ESC/POS Compatibility
Vertical Solution
Wall Mount Kit
FONT A(9x9 dots)
<21h-FFh codes printed by BLACK>
<21h-FFh codes printed by RED>
FONT B(7x9 dots)
<21h-FFh codes printed by BLACK>
<21h-FFh codes printed by RED>
Printed by CD-S500
<Soft Control-SW> - - - - - - - - - - - - - -
Command Type -EPSON
Number of Col. -40/33
Font Select -7 × 9
Paper Plies -OFF
Paper End -ENB
Paper Near-End -ENB
Slashed Zero -OFF
Print Direct. -BI-DIR
Auto LF -OFF
Code Page -437
Buffer Size -4K
Init Signal -ENB
Buzzer -ON
<Interface-SW> - - - - - - - - - - - - -
Baud Rate -19200
Data Length -8bit
Parity Bit -NONE
Stop Bit -1bit
Protocol -DTR
<Mechanical-SW> - - - - - - - - - - - - - -
Paper Width -76.2
Auto-Cutter -FREE
Color Ribbon -ON
Take-Up Device -ON