Service manual

6-6
CD-S500 Series
6-4 Error Indication
Errors are indicated by a combination of POWER, P.OUT, and ERROR LEDs.
(Each and represents 300 ms.)
: Lit, : Off
* No RS232C communication error detection is performed.
Type of Error LED Indication Operation and Restoration Method
(1) Paper end
POWER
P.OUT
ERROR
Printing stops and the printer goes offline.
Replace the paper and close the cover to
return the printer online.
Paper end can be disabled by setting ESC c
4.
(2)
Paper near
end
POWER
P.OUT
ERROR
When PAPER NEAREND of the soft switch
is enabled, printing continues after PE,
FAULT is output. When it is disabled, the
LEDs keep flashing and printing continues to
the paper end.
(3)
Rear/front
cover open
POWER
P.OUT
ERROR
Depends on the status
During printing, printing is immediately
stopped and the printer goes offline.
Close the cover to return the printer online.
(4) Head hot
POWER
P.OUT
ERROR
Depends on the status
Cooling starts.
After the temperature has fallen, the printer
is automatically restored and printing
restarts.
(5) HP abnormal
POWER
P.OUT
ERROR
The printer goes offline. Remove the paper
jam or other problem and press FEED switch
to restore the printer. The printer returns to
online status after initial operation.
(6)
Black mark
abnormal
POWER
P.OUT
ERROR
The printer goes offline. Remove the paper
jam or other problem and press FEED switch
to restore the printer. The printer returns to
online status after initial operation.
(7)
Cutter abnormal
position detection
POWER
P.OUT
ERROR
The printer goes offline. Remove the paper
jam or other problem and press FEED switch
to restore the printer. The printer returns to
online status after initial operation.
(8)
Hardware
abnormal
RAM readwrite
POWER
P.OUT
ERROR
When the power is on, it means that a
hardware error, such as RAM check,
occurred.
The printer goes offline, and then an error is
indicated. Restoration impossible.
(9)
Hardware
abnormal
FROM write
POWER
P.OUT
ERROR
FROM writing error.
The printer goes offline, and then an error is
indicated. Restoration impossible.
(1
0)
24V abnormal
POWER
P.OUT
ERROR
24V voltage abnormal.
The printer goes offline, and then an error is
indicated. Restoration impossible.