Operator`s manual

48
Getting started
Driving
Wiping with windshield washer fluid
왘 Push switch in the direction of arrow 1
past the resistance point.
The windshield wiper operates with
washer fluid.
Problems while driving
The engine runs erratically and misfires
앫 An ignition cable may be damaged.
앫 The engine electronics may not be op-
erating properly.
앫 Unburned gasoline may have entered
the catalytic converter and damaged it.
왘 Give very little gas.
왘 Have the problem repaired by an au-
thorized Mercedes-Benz Center as
soon as possible.
The coolant temperature is over 248°F
(120°C)
The coolant is too hot and is no longer
cooling the engine.
왘 Stop the vehicle as soon as possible
and turn off the engine. Allow engine
and coolant to cool.
왘 Check the coolant level and add cool-
ant if necessary (
컄 page 268).
!
If leaves, snow, etc. block the wind-
shield wipers, switch off the wipers.
앫 For safety reasons, withdraw
SmartKey from starter switch. Re-
move blockage.
앫 Turn the windshield wipers on
again.
If windshield wipers fail to function at
all in switch position I:
앫 Set the combination switch to the
next highest wiper speed.
앫 Have the windshield wipers
checked at the nearest authorized
Mercedes-Benz Center.