Operator`s manual

341
Practical hints
Flat tire
1 Jack support tube hole
2 Jack arm
3 Crank
왘 Insert jack arm 2 fully into tube hole 1
up to the stop.
왘 Keeping jack in this position, turn
crank 3 clockwise until the jack base
meets the ground. Make sure the jack
is vertical (plumb line).
왘 Continue to turn the crank until the tire
is a maximum of 1.2 in (3 cm) from the
ground.
Removing the wheel
1 Alignment bolt
왘 Unscrew upper-most wheel bolt and re-
move.
왘 Replace this wheel bolt with alignment
bolt 1 supplied in the tool kit.
왘 Remove the remaining bolts.
왘 Remove the wheel.
Warning! G
Insert the jack arm fully into the jack sup-
port tube hole up to the stop. Otherwise the
vehicle may fall from the jack and cause per-
sonal injury or damage to the vehicle.
Warning! G
The jack is intended only for lifting the vehi-
cle briefly for wheel changes. It is not suited
for performing maintenance work under the
vehicle.
앫 Never start the engine when the vehicle
is raised.
앫 Never lie down under the raised vehicle.
!
Do not place wheel bolts in sand or dirt.
This could result in damage to the bolt
and wheel hub threads.