Operator`s manual

274
Operation
Engine compartment
Checking the engine oil level with the
control system
When checking the oil level the vehicle
must
앫 be parked on level ground
앫 be at normal operating temperature
앫 have been stationary for at least five
minutes with the engine turned off
To check the engine oil level via the multi-
function display, do the following:
왘 Turn the SmartKey in the starter switch
to position 2 or press the KEYLESS-GO
start/stop button* twice.
The standard display (
컄 page 139) should
appear in the multifunction display.
왘 Press button k or j on the
steering wheel until the following mes-
sage is seen in the multifunction dis-
play:
CORRECT MEASUREMENT
ONLY IF VEH. LEVEL
After about three seconds this mes-
sage is displayed:
ENGINE OIL LEVEL
MEASURING NOW
!
One of the following messages will sub-
sequently appear in the indicator:
앫 ENGINE OIL LEVEL
OK
앫 ADD 1.0 QT. TO
REACH MAX. OIL LEVEL!
(Canada: 1.0 LITER )
앫 ADD 1.5 QTS. TO
REACH MAX. OIL LEVEL!
(Canada: 1.5 LITERS )
앫 ADD 2. 0 QT S .
TO REACH MAX. OIL LEVEL!
(Canada: 2.0 LITERS )
왘 If necessary, add engine oil.
For adding engine oil see (
컄 page 277).
For more information on engine oil, see
the “Technical data” section (
컄 page 391)
and (
컄 page 393).
i
If you want to interrupt the checking
procedure, press the k or j
button on the multifunction steering
wheel.