User`s manual

7
PREPARATION
a) Connect the cables between ECR and PC. Refer to Refer to VIII. Cable Connection (page 25).
- Connect ECRs and network adapter NA-720's master channel by IRC line.
- Connect RS232C line between PC and NA-720's CH-1.
b) Confirm the following settings;
- Perform "PC - NA-720 - ECR settings" on PC. Refer to Tensai2000 help.
- Program the followings on each ECR;
Select the host ID by [SF-82.c~h].
Select the data file by [SF-4.a~d].
Set the baud rate of IRC line by [SF-89.a].
Set the tolerance time limit by [SF-95.b~h].
c) Perform [COMMUNICATION]-[STATUS CHECK] on Tensai2000. This is necessary to
communicate with ECRs.
d) Make each data file for the real-time communication by Tensai2000.
- Before you make a data file, perform two steps on Tensai2000;
1. [COMMUNICATION]-[GET ECR RAM DATA]
2. [EDIT]-[MAKE UDB FILE]
These steps are necessary to get the program data in ECR which is required to make a data file
for the real-time communication.
- Then, perform [EDIT]-[REALTIME COMM. DATA] to make data files.