User`s manual

VI. ECR TO ECR RAM DATA TRANSFER

ECR to ECR RAM data transfer is done by using channel B.

This transfer will send the programming data and sales data. If only the programming data is

required, reset the sales data by issuing all Z-reports, then follow the sequence below.

PREPARATION

a) Set the same baud rate for both ECRs by [SF-89.d,e].

[SF-89.d,e] [00] 38400 bps, [01] 19200 bps, [10] 9600 bps

b) Connect the ECR to another ECR by using channel B.

Refer to VIII. Cable Connection (page 29).

RAM DATA TRANSFER

1) On ECR B, perform the sequence below. Check that "--- PC-IN ---" is displayed.

< SP >--{(1002)--[X/ENTER] or select 1002 COMM LOAD from the list}--[X/ENTER]

2) On ECR A, perform the sequence below.

"--- PC-OUT ---" is displayed during the communication.

< SP >--{(1001)--[X/ENTER] or select 1001 COMM DUMP from the list}--[X/ENTER]