User`s manual

5) TM-T88III (connected to ch-B)

ECR SETTINGS

a) Program the following;

[SF-83.h] [1] with slip printer

[SF-87.a,b] slip printer selection: [10] TM-T88III

[SF-94.a~d] [0111] even parity, 8-bit data, 2 stop bits for channel B

Baud rate 19200 bps has been fixed for thermal slip printer of channel B.

b) See [SF-83 ~ 87] for other selections, such as time print, logo print, automatic slip print, etc.

TM-T88III SETTINGS

TM-T88III-UW(s) ROM for ECR character must be replaced by the installed standard ROM on the

printer.

Turn off the printer power button and set the dip switches as shown below;

Turn on the power button to fix the setting.

DSW 1 CONTENTS DSW 2 CONTENTS

1 ON ignores data reception errors 1 OFF

busy condition :

off line or data buffer full

2 OFF data buffer : 4K bytes 2 OFF printing density level 2 (standard)

3 ON XON/XOFF control 3 OFF (fixed)

4 OFF 8-bit data 4 OFF (fixed)

5 ON parity enabled 5 OFF (fixed)

6 ON even parity 6 OFF (fixed)

7 OFF 7 OFF #6 pin reset signal not used

8OFF

19200 bps

8 OFF #25 pin reset signal not used