User`s manual

11
4) CBM-1000 (connected to ch-B)
CBM-1000-UW ROM for ECR character must be replaced by the installed standard ROM on the
printer.
ECR SETTINGS
a) Program the following;
[SF-83.h] [1] with slip printer
[SF-87.a,b] slip printer selection: [11] CBM-1000
[SF-94.a~d] [0111] even parity, 8-bit data, 2 stop bits for channel B
Baud rate 19200 bps has been fixed for thermal slip printer of channel B.
b) See [SF-83 ~ 87] for other selections, such as time print, logo print, automatic slip print, etc.
CBM-1000 SETTING
DIP SW CBM-1000
DS 1 - 1 ON with auto cutter
DS 1 - 2 ~ 4 OFF,OFF,OFF,OFF print mode: high-speed, paper width: 80 mm, print columns: 48
DS 1 - 5 ON CR mode: LF operation
DS 1 - 6 OFF input buffer: 4K bytes
DS 1 - 7, 8 ON,OFF print density : standard
DS 2 - 1 ~ 4 all OFF ECR character set
DS 2 - 5 ~ 8 all OFF JIS, condition for busy to occur: off-line and reception buffer full
DS 3 - 1 ~ 4 OFF,ON,ON,ON 8-bit data, even parity, XON/XOFF control
DS 4 - 1 ~ 4 ON,ON,OFF,OFF 19200 bps (RS232C)