User`s manual

10
3) CBM-1000 (connected to ch-A via NA-710/730)
CBM-1000-UW ROM for ECR character must be replaced by the installed standard ROM on the
printer.
ECR SETTINGS --- same settings as TP-822/832 (page 8)
NETWORK ADAPTER SETTINGS
NA-710 : 1 printer can be connected
NA-730 : up to 3 printers can be connected
Unplug the cord and set the dip switches as shown below;
Plug the cord to fix the setting.
DIP SW NA-710/730
SW1 - 1, 2 [OFF,ON] 19200 bps for RS232C (set the same baud rate as printer)
SW1 - 3 Baud rate for RS485 (set the same baud rate as ECR [SF-89.a]): [ON] 38400 bps [OFF] 19200 bps
SW2 - 1 [OFF] printer ID # 1 ~ 4 [ON] printer ID # 5 ~ 8 (also set SW3, SW4)
SW2 - 2 ~ 4 [OFF,OFF,OFF] printer selection CBM-1000
SW3 - 1 [OFF] auto cut at text end
SW3 - 2 [ON] full cut [OFF] partial cut
SW3 - 3, 4
NA-710 / CH-1 of NA-730
[SW2-1=OFF] → [OFF,OFF] ID# 1 [ON,OFF] ID# 2 [OFF,ON] ID# 3 [ON,ON] ID# 4
[SW2-1=ON] → [OFF,OFF] ID# 5 [ON,OFF] ID# 6 [OFF,ON] ID# 7 [ON,ON] ID# 8
SW4 - 1, 2
CH-2 of NA-730
[SW2-1=OFF] → [OFF,OFF] ID# 1 [ON,OFF] ID# 2 [OFF,ON] ID# 3 [ON,ON] ID# 4
[SW2-1=ON] → [OFF,OFF] ID# 5 [ON,OFF] ID# 6 [OFF,ON] ID# 7 [ON,ON] ID# 8
SW4 - 3, 4
CH-3 of NA-730
[SW2-1=OFF] → [OFF,OFF] ID# 1 [ON,OFF] ID# 2 [OFF,ON] ID# 3 [ON,ON] ID# 4
[SW2-1=ON] → [OFF,OFF] ID# 5 [ON,OFF] ID# 6 [OFF,ON] ID# 7 [ON,ON] ID# 8
CBM-1000 SETTING
Turn off the printer power button and set the dip switches as shown below:
Turn on the power button to fix the setting.
DIP SW CBM-1000
DS 1 - 1 ON with auto cutter
DS 1 - 2 ~ 4 OFF,OFF,OFF,OFF print mode: high-speed, paper width: 80 mm, print columns: 48
DS 1 - 5 ON CR mode: LF operation
DS 1 - 6 OFF input buffer: 4K bytes
DS 1 - 7, 8 ON,OFF print density : standard
DS 2 - 1 ~ 4 all OFF ECR character set
DS 2 - 5 ~ 8 all OFF JIS, condition for busy to occur: off-line and reception buffer full
DS 3 - 1 ~ 4 OFF,ON,ON,OFF 8-bit data, even parity, DTR/DSR control
DS 4 - 1 ~ 4 ON,ON,OFF,OFF 19200 bps (RS232C)