User`s manual

CBM-292/293 User’s Manual
26 CITIZEN
4.7 Remedies for Paper Jam and Cutter Lock
If the paper jams or the auto cutter is locked, follow the procedure below to eliminate the cause. For your
safety, be sure to turn off the power prior to starting the work.
(1) Open the front cover.
(2) Press the mechanical lock lever inward, to lower the mechanism.
(3) Eliminating a paper jam. Eliminate all the jamming paper carefully and gently. When pulling out the
paper from the printer mechanism, move up the printing head and pull it out gently.
(4) Unlocking the cutter. Eliminate the paper from the cutter section, and turn on the power. Cutter
unlocking operation will be completed if the cutter blade returns and the initial operation is performed.
If the cutter blade does not return or an error recurs, turn off the power, and turn the left inner knob of the
cutter toward the far side, as shown in the figure below. Since the cutter blade withdraws, eliminate the
caught paper gently. Then, turn on the power and confirm that the initial operation is performed.
(5) After eliminating the cause, raise the mechanism back to its home position, return the head up lever, and
turn on the power again.
CAUTION :
•
Never work with the printing head or motor immediately after printing, as they
are hot and can burn you.
If such work is unavoidable, never touch them directly.
•
Be careful to avoid injury by the metal edges.
4.8 Self-Printing Function
The characters used, ROM version, and DIP switch information are printed by turning on the power with the
FEED switch held down or inputting a RESET signal. If the auto-cutter is attached, the paper will be cut after
printing.