Operating instructions

— 31 —
1
2
3
DS1 ( For Serial Interface/Parallel Interface)
No.
1
2
3
4
5
6
7
8
Function
PNE selection
CR switching
Print density
Low Voltage signal
Auto-loading
DTR/DSR, XON/XOFF
Kanji code selection
ON
Enabled
LF operation
Enabled
Enabled
XON/XOFF
S-JIS
Upon Shipment
ON
OFF
ON
OFF
OFF
ON
OFF
OFF
OFF
Disabled
Ignored
Disabled
Disabled
DTR/DSR
JIS
See Table 1
Table1
DS1-3
DS1-4
Light
OFF
OFF
Standard
ON
OFF
Dark
ON
ON
Slightly Dark
OFF
ON
*DS1-5: DTR signal for the serial interface
SELECT signal for the parallel interface
*DS1-7: Enabled only for the serial interface. Disabled for the parallel one.
5. DIP SWITCH SETTING
5.1 Location of DIP Switch
Turn off the power.
Detach the printer cover, and take out the paper roll. (The switch is found under the
paper roll.)
There are 2 switches (8-pole and 4-pole) for the serial interface, and 2 switches (8-
pole and 4-pole) for the parallel interface.
5.2 DIP Switch Function