Operating instructions

— 26 —
(2) Print amount after detecting PNE
When PNE is enabled, a printable amount after PNE detection can be adjusted.
PNE is detected when the remaining amount of the paper roll is about 2~3 m.
(It depends on the paper quality used, paper thickness, and operating
environment.)
An initial value is 1.5 m. Up to 1.5 m can be printed after detecting PNE. At
this time, with the approx. 70µm-thick recommended paper, the remaining
amount of the paper will be about 0.5~1.5 m when printing stops.
It can be adjusted between 0 and 2.55 m with a command. Adjust it
depending on the operating environment and paper quality.
Depending on an adjustment value, paper end may be detected (Printing stop)
first.
If PNE is detected at power-on, a set amount of printing will be done from that
point. (The default is 1.5 m)