Operating instructions

— 10 —

4. OPERATION

4.1 Connecting AC Adapter

Turn off the power.

Connect the cable connector of the AC adapter to the power connector located on

the back of the printer.

Connect the AC power cord of the AC adapter, and plug it into a socket.

(For the details of printer status, see “Operation Panel and Display of Error” in

Section 4.15.)

CAUTION:

• Use only the specified AC adapter.

• When disconnecting/reconnecting the cable connector of the AC adapter, be sure to

hold the connector.

• Separate the AC adapter from other noise-generating devices.

• Pulling the AC power cord may damage it, resulting in a fire, electric shock, or

snapping.

• If a thunder/lightning storm is nearby, disconnect the AC adapter from the socket

and do not use the printer, because a fire or electric shock may occur.

• Do not put the AC power cord close to a heating device. Its coating can melt and

cause a fire or electric shock.

• Install the printer in a well-ventilated place, because the AC adapter generates heat

when it is used.

• Use the specified AC power source. Connect to a power source with sufficient

capacity. If the capacity is insufficient, a fire may result from heat generation.

• After using the printer or when not using it for a long period of time, be sure to

unplug the AC adapter from a plug socket for your safety.

• Before connectiong the AC adapter be sure to set the POWER switch to OFF.

— 10 —