Operating instructions

— 6 —

2.3 Paper Specifications

2.3.1 Recommended Paper

• Type : Thermal paper

• Paper width : 58 + 0/– 1 mm

• Paper thickness : 60~75µm

• Roll diameter : ø83 mm or less

• Printing surface : Outside of the roll (Surface)

• Recommended paper : TF50KS-E2C (Monochrome) made by NIPPON PAPER or

its equivalent 735 FA (2-color, Black based) made by

RICOH or its equivalent PB670 (2-color, Red based)

made by MITSUBISHI PAPER or its equivalent

• Core : ø12 mm (Inner dia.), (18 mm øOuter dia.)

CAUTION:

• Use of non-specified paper may cause irregularity of print density. If this is the case,

use the DIP switch to reset print density. (See 5. DIP SWITCH SETTING)

• Do not paste the paper to the core.

• If the paper comes in contact with a chemical or oil, it may discolor or lose a record.

• Do not rub the paper surface strongly with a nail or hard metal. It may discolor.

• Discoloring starts at about 70°C. Watch out for effects of heat, humidity, light, and

so on.