User`s manual

CBM-202PC-04 User’s Manual
52 CITIZEN
ESC * m n1 n2 [ d ] k
[Function] Specifying the Bit Image Mode
[Code] <1B>H<2A>H<m><n1><n2> [ <d> ] k
[Range] {m= 0, 1, 32, 33 bit image mode (See the table below.)}
{0  n1  FF(Hex)}
{0  n2  03(Hex)}
{0  d  FF(Hex)}
{k = n1 + FF(Hex) X n2 (m = 0, 1)
{k = (n1+ FF(Hex) X n2) X 3} (m = 32, 33)
[Outline] According to the number of dots specified in n1, n2, specify the bit image of
mode n.
• The No. of dots printed is divided by 256, whose quotient is taken as n2
and residualas n1.
• The total no. of dots printed in the bit image is equal to n1 + (256 x n2).
• When bit image data have been input in excess of dot position of one
line(448 dots) , the excess data are discarded.
• d is bit image data, the bits subject to printing are taken as "1" and those
not as "0".
• The bit image modes specified by m are shown as follows:
Vertical Direction Horizontal Directionm(Hex) Mode
No. of Dots Dot Density Dot Density Max. No. of Dots
0 8-dot single density 8 67 DPI 101 DPI 192
1 8-dot double density 8 67 DPI 203 DPI 384
32 24-dot single density 24 203 DPI 101 DPI 192
33 24-dot double density 24 203 DPI 203 DPI 384
[Caution] • When the values set in m (Bit image mode) are out of the above range,
the data following after n1 is processed as normal printing data.
• After completion of bit image printing, printer returns to normal data
processing mode.