User`s manual

CBM-202PC-04 User’s Manual
27 CITIZEN
4.16 Function Selection Circuit
The input port of the Gate Array has function selecting terminals. When connecting the DIP
switch, and so on, connect them as they are. When fixing with a Jumper, and so on, only the
terminals you want to set to "LOW" should be connected to GND.
Gate Array
Pin No. Signal
Function “LOW” “HIGH”
33 PAI0 Auto cutter Enabled Disabled
32 PAI1 CR change LF operation Ignored
31 PAI2 Printing density See Table (3)
30 PAI3 DTR/XON–XOFF XON–XOFF DTR/DSR
29 PAI4
28 PAI5
27 PAI6
26 PAI7
Interface See Table (1)
PAI3 is valid only when the serial interface is used.
Gate Array
Pin No. Signal
Function “LOW” “HIGH”
43 PBI0
42 PBI1
39 PBI2
International
characters selection
See Table (2)
38 PBI3 Auto loading Enabled Disabled
37 PBI4 Drive system Dynamic drive Fixed division
36 PBI5 Printing density See Table (3)
35 PBI6 Unused - -
34 PBI7 Unused - -
PAI6 is valid only when the serial interface is used.