User`s manual
CBM-202PC-04 User’s Manual
26 CITIZEN
3) Resetting methods
Error Resetting Method
No-paper Set the paper. See Note 1.
Head-up Shift down the head-up lever.
VH voltage error
Set the VH voltage to within the allowable range(4.2~8.5 V) and
turn on the power again, or set the LFSW(Pin-2) of the CPU to
Active. See Note 2.
Head temperature error
At the lower limit(Less than 0ºC), printing is enabled at 0ºC or
more. At the upper limit(65ºC or more), printing is enabled at
60C or less.
Cutter lock(ACS-220-5v)
Eliminate the paper jam and set LFSW(Pin-2) of the CPU to Active
or turn on the power again.
Note)
1. If auto loading has not been selected with the function selection J4(Jumper), set the
paper manually. If it has been selected, the auto loading function will be enabled to
facilitate paper replacement.
2. The upper-limit voltage of 8.5V for the VH voltage error is a voltage assumed only
immediately after charging the battery when the battery power is used and cannot be
normally used. A maximum normal voltage is 7.2V.