Setup guide

CITIZEN OPOS DRIVER 1.8 Setup Guide

4) “Details of settings” window is displayed.

Settings of each item are as shown below.

Status Back interval

Sets the polling interval for acquiring printer status.

Setting range: 100 to 900 msec

Write Timeout

Sets the write timeout for output port.

Setting range: 5000 to 100,000 msec

Active Paper Sensor

Specify the paper sensor set to be logically active on the driver.

Set value: Paper End/Paper Near-End

This setting is interlocked with the CapRecEmptySensor property and RecEmpty property.

For details of the above properties, refer to Application Development Guide of this product.

International Char

Specifies a international character table to use.

Set value: U.S.A/France/Germany/U.K./DenmarkI/Sweden/Itary/SpainI/Japan/Norway/DenmarkII/

SpainII/ Latin America/Korea

SetBitmap Mode

Specifies the bit image mode of the SetBitmap method. For details of this mode, refer to Application

Development Guide of this product.

Set value: NV bit image/Raster bit image

Bitmap image size

Specifies the rate of print enlargement of the bit image registered in the SetBitmap method.

Set value: Normal/Double-Width/Double-Height/Quadruple

Map image with Printer Resolution

When this setting is enabled, the setting of “Bit image size” is effective.

When this setting is disabled, it is treated as the size (Normal) of the bit image registered in the

SetBitmap method.

After the above setting, click [Next].