Specifications

II Parameters
Machining Parameters
II - 1
1. Machining Parameters
The parameters with "(PR)" requires the CNC to be turned OFF after the settings. Turn the power OFF and
ON to enable the parameter settings.
【#8001】 WRK COUNT M
Set the M code for counting the number of the workpiece repeated machining.
The number of the M-codes set by this parameter is counted.
The No. will not be counted when set to "0".
---Setting range---
0 to 99
【#8002】 WRK COUNT
Set the initial value of the number of workpiece machining. The number of current
workpiece machining is displayed.
---Setting range---
0 to 999999
【#8003】 WRK COUNT LIMIT
Set the maximum number of workpiece machining.
A signal will be output to PLC when the number of machining times is counted to this limit.
---Setting range---
0 to 999999
【#8004】 SPEED
Set the feedrate during automatic tool length measurement.
---Setting range---
1 to 1000000 (mm/min)
【#8005】 ZONE r
Set the distance between the measurement point and deceleration start point.
---Setting range---
0 to 99999.999 (mm)
【#8006】 ZONE d
Set the tolerable range of the measurement point.
An alarm will occur when the sensor signal turns ON before the range, set by this
parameter, has not been reached from the measurement point, or when the signal does not
turn ON after the range is passed.
---Setting range---
0 to 99999.999 (mm)
【#8007】 OVERRIDE
Set the override value for automatic corner override.
---Setting range---
0 to 100 (%)
【#8008】 MAX ANGLE
Set the maximum corner opening angle where deceleration should start automatically.
When the angle is larger than this value, deceleration will not start.
---Setting range---
0 to 180 (°)
【#8009】 DSC. ZONE
Set the position where deceleration starts at the corner.
Designate at which length point before the corner deceleration should start.
---Setting range---
0 to 99999.999 (mm)
【#8010】 ABS. MAX. (for L system only)
Set the maximum value when inputting the tool wear compensation amount.
A value exceeding this setting value cannot be set.
---Setting range---
0 to 99.999 (mm)
【#8011】 INC. MAX. (for L system only)
Set the maximum value for when inputting the tool wear compensation amount in the
incremental mode.
A value exceeding this setting value cannot be set.
---Setting range---
0 to 99.999 (mm)
【#8012】 G73 n (for M system only)
Set the return amount for G73 (step cycle).
---Setting range---
0 to 99999.999 (mm)