Specifications
Table Of Contents
- Front cover
- Trademarks
- Contents
- Remedy and measure after a report of error
- I Alarms
- 1. Operation Errors (M)
- 2. Stop Codes (T)
- 3. Servo/Spindle Alarms (S)
- 4. MCP Alarms (Y)
- 5. Safety Observation Alarms (Y)
- 6. System Alarms (Z)
- 7. Absolute Position Detection System Alarms (Z7*)
- 8. Emergency Stop Alarms (EMG)
- 9. Auxiliary Axis Operation Errors (M)
- 10. CNCCPU-side Safety Sequence Alarm(U)
- 11. Multi CPU Errors (A)
- 12. Network Errors (L)
- 13. Program Errors (P)
- II Parameters
- 1. Machining Parameters
- 2. Base Specifications Parameters
- 3. Axis Specifications Parameters
- 4. Servo Parameters
- 5. Spindle Parameters
- 6. Multi-CPU Parameters
- 7. FL-net Parameters
- 8. DeviceNet Parameters
- 9. Machine Error Compensation Parameters
- 10. PLC Parameters
- 11. Macro List
- 12. Position Switches
- 13. PLC Axis Indexing Parameters
- III PLC Devices
- Revision History
- Back cover
I Alarms
Multi CPU Errors (A)
I - 64
A01 MULTI CPU ERROR 8031
Details
- An error of a stored file (valid parameter file) was detected.
Remedy
- Write the file indicated by the individual information SD17 to SD22 into the individual infor-
mation SD16(L), and turn the CPU power OFF and ON or execute 'reset' and 'reset cancel-
ing'.
- If the same error is displayed again, this suggests a CPU module hardware fault. Contact
your local service center.
A01 MULTI CPU ERROR 9000
Details
- Annunciator (F) was set ON
Remedy
- Read the individual information of the error using a programming tool, and check the pro-
gram corresponding to the numerical value (annunciator number).
A01 MULTI CPU ERROR 10001-10999
Details
- Motion controller in the multi-CPU system has an error.
(QnUD(H)CPU does not lead this error.)
Remedy
- Read the error details using a programming tool for the motion controller, and remove the
error factor.
A01 MULTI CPU ERROR 11000-11999
Details
- CNC CPU in the multi-CPU system has an error.
(QnUD(H)CPU does not lead this error.)
Remedy
- See the error details on the NC display and remove the error factor.
A01 MULTI CPU ERROR 12000-12999
Details
- RC CPU in the multi-CPU system has an error.
(QnUD(H)CPU does not lead this error.)
Remedy
(Reserved for RC.)