Specifications
Table Of Contents
- Front cover
- Trademarks
- Contents
- Remedy and measure after a report of error
- I Alarms
- 1. Operation Errors (M)
- 2. Stop Codes (T)
- 3. Servo/Spindle Alarms (S)
- 4. MCP Alarms (Y)
- 5. Safety Observation Alarms (Y)
- 6. System Alarms (Z)
- 7. Absolute Position Detection System Alarms (Z7*)
- 8. Emergency Stop Alarms (EMG)
- 9. Auxiliary Axis Operation Errors (M)
- 10. CNCCPU-side Safety Sequence Alarm(U)
- 11. Multi CPU Errors (A)
- 12. Network Errors (L)
- 13. Program Errors (P)
- II Parameters
- 1. Machining Parameters
- 2. Base Specifications Parameters
- 3. Axis Specifications Parameters
- 4. Servo Parameters
- 5. Spindle Parameters
- 6. Multi-CPU Parameters
- 7. FL-net Parameters
- 8. DeviceNet Parameters
- 9. Machine Error Compensation Parameters
- 10. PLC Parameters
- 11. Macro List
- 12. Position Switches
- 13. PLC Axis Indexing Parameters
- III PLC Devices
- Revision History
- Back cover
II Parameters
Spindle Parameters
II - 123
【#13248(PR)】 SP248
This is automatically set by the NC system.
【#13249(PR)】 SP249
This is automatically set by the NC system.
【#13250(PR)】 SP250
This is automatically set by the NC system.
【#13251(PR)】 SP251
This is automatically set by the NC system.
【#13252(PR)】 SP252
This is automatically set by the NC system.
【#13253(PR)】 SP253
This is automatically set by the NC system.
【#13254(PR)】 SP254
This is automatically set by the NC system.
【#13255(PR)】 SP255
This is automatically set by the NC system.
【#13256(PR)】 SP256
This is automatically set by the NC system.