Specifications

II Parameters
Spindle Parameters
II - 103
【#13035(PR)】 SP035 SFNC3 Spindle function 3
Select the spindle function.
A function is allocated to each bit.
Set this in hexadecimal format.
bit F-D :
Not used. Set to "0".
bit C : shgn SHG control in interpolation mode
0: Stop 1: Start
When using the OMR-FF control, set to "0".
bit B :
Not used. Set to "0".
bit A : pyn Excitation rate selection in interpolation mode
0: Select Excitation rate 1 1: Select Excitation rate 2
bit 9 : vgn Speed loop gain set selection in interpolation mode
0: Select Set 1 1: Select Set 2
bit 8-3 :
Not used. Set to "0".
bit 2 : pyin Excitation rate selection in non-interpolation mode
The excitation rate after the in-position can be selected.
0: Select Excitation rate 1 1: Select Excitation rate 2
bit 1 : vgin Speed loop gain set selection in non-interpolation mode
The speed loop gain set after the in-position can be selected.
0: Select Set 1 1: Select Set 2
bit 0 :
Not used. Set to "0".
【#13036(PR)】 SP036 SFNC4 Spindle function 4
Select the spindle function.
A function is allocated to each bit.
Set this in hexadecimal format.
bit F-8 :
Not used. Set to "0".
bit 7 : mksl Coil selection in spindle synchronization mode
0: Select the coil commanded during synchronization 1: Select high-speed coil
bit 6-5 :
Not used. Set to "0".
bit 4 : shgs SHG control in spindle synchronization mode
0: Stop 1: Start
When using the OMR-FF control, set to "0".
bit 3 :
Not used. Set to "0".
bit 2 : pys Excitation rate selection in spindle synchronization mode
0: Select Excitation rate 1 1: Select Excitation rate 2
bit 1 : vgs Speed loop gain set selection in spindle synchronization mode
0: Select Set 1 (SP005,SP006,SP007) 1: Select Set 2 (SP008,SP009,SP010)
bit 0 :
Not used. Set to "0".