Specifications

II Parameters
Axis Specifications Parameters
II - 52
【#2051】 check Check
Set the tolerable range of travel distance (deviation distance) while the power is turned
OFF.
If the difference of the positions when the power is turned OFF and when turned ON again
is larger than this value, an alarm will be output.
Set "0" to omit the check.
---Setting range---
0 to 99999.999 (mm)
【#2052】 absg28 Width compared by G28
Set the allowable range of the comparison result when comparing the positions during G28
or G30.
0: Not compare
1 to 65535 (in increments of 0.5μm):
If the difference between the position read by the detector and that in the control unit
exceeds this range, an alarm will be output to stop the machine. The standard
setting is 100.
---Setting range---
0 to 65535 (0.5μm)
【#2053】 absm02 Width compared by M02
Set the allowable range of the comparison result when comparing the positions during M02
or M30.
0: Not compare
1 to 65535 (in increments of 0.5μm):
If the difference between the position read by the detector and that in the control unit
exceeds this range, an alarm will be output to stop the machine. The standard
setting is 100.
---Setting range---
0 to 65535 (0.5μm)
【#2054】 clpush Current limit (%)
Set the current limit value during the stopper operation in the dogless-type absolute position
detection.
The setting value is the ratio of the current limit value to the rated current value.
---Setting range---
0 to 100 (%)
【#2055】 pushf Push speed
Set the feedrate for the automatic initial setting during stopper method.
---Setting range---
1 to 999 (mm/min)
【#2056】 aproch Approach
Set the approach distance of the stopper when deciding the absolute position basic point
with the stopper method.
After using stopper once, the tool returns with this distance, and then use stopper again.
---Setting range---
0 to 999.999 (mm)
【#2057】 nrefp Near zero point +
Set the positive direction width where the near reference position signal is output.
When set to "0", the width will be equivalent to the grid width setting.
---Setting range---
0 to 32.767 (mm)
【#2058】 nrefn Near zero point -
Set the negative direction width where the near reference position signal is output.
When set to "0", the width will be equivalent to the grid width setting.
---Setting range---
0 to 32.767 (mm)
【#2059】 zerbas Select zero point parameter and basic point
Select which is to be the zero point coordinate position during absolute position initial
setting.
0: Position where the axis was stopped.
Marked point in marked point alignment method.
1: Grid point just before stopper.
On the grid point just before the marked point in marked point alignment method.
【#2061】 OT_1B- Soft limit IB-
Set the coordinate of the lower limit of the area where the stored stroke limit IB is inhibited.
Set a value from zero point in the basic machine coordinate system.
If the same value (non-zero) with the same sign as that of "#2062 OT_IB+" is set, the stored
stroke limit IB function will be disabled.
---Setting range---
-99999.999 to 99999.999 (mm)