Specifications

II Parameters
Axis Specifications Parameters
II - 49
【#2020】 o_chkp Spindle orientation completion check during second reference position
return
Set the distance from the second reference position to the position for checking that the
spindle orientation has completed during second reference position return.
When the set value is "0", the above check will be omitted.
---Setting range---
0 to 99999.999 (mm)
【#2021】 out_f Maximum speed outside soft limit range
Set the maximum speed outside the soft limit range.
---Setting range---
0 to 1000000 (mm/min)
【#2022】 G30SLX Validate soft limit (automatic and manual)
Select whether to disable a soft limit check during the second to the fourth reference
position return in both automatic and manual operation modes.
0: Enable
1: Disable
【#2023】 ozfmin Set up ATC speed lower limit
Set the minimum speed outside the soft limit range during the second to the fourth
reference position return.
---Setting range---
0 to 1000000 (mm/min)
【#2024】 synerr Allowable error
Set the maximum synchronization error, allowable at the synchronization error check, for
the primary axis.
When “0” is set, the error check will not be carried out.
---Setting range---
0 to 99999.999 (mm)
【#2025】 G28rap G28 rapid traverse rate
Set a rapid traverse rate for the dog type reference position return command.
---Setting range---
1 to 1000000 (mm/min)
【#2026】 G28crp G28 approach speed
Set the approach speed to the reference position.
(Note) The G28 approach speed unit is (10°/min) only when using the Z-phase type
encoder (#1226 aux10/bit3=1) for the spindle/C-axis reference position return type.
The same unit is used for both the micrometric and sub-micrometric specifications.
---Setting range---
1 to 60000 (mm/min)
【#2027】 G28sft Reference position shift distance
Set the distance from the electrical zero-point detection position to the reference position.
---Setting range---
0 to 65535 (μm)
【#2028】 grmask Grip mask amount
Set the distance where the grid point will be ignored when near-point dog OFF signals are
close to that grid point during reference position return.
The grid mask is valid for one grid.
---Setting range---
0 to 65535 (μm)
Even for the specifications in sub-micrometric system, set up the value in units of μm.
A
xis speed
Grid
Electrical zero point
Near-point dog
Grid mask setup distance
Position
(Detector F/B)