Specifications

II Parameters
Base Specifications Parameters
II - 34
【#1388】 Alm42Bord Alarm displaying threshold (42)
Set threshold for turning ON the detector alarm (42).
The threshold is "1" when "0" is set.
---Setting range---
0 to 3
【#1493(PR)】 ref_syn Synchronization at zero point initialization
(Note) Set to "1" for position command synchronization control.
0 : Primary axis and secondary axis determine their zero points individually.
1 : The zero points of both primary and secondary axes are determined by initializing
the primary axis' zero point.
When using the stopper method and either the primary axis or the secondary axis
reaches the current limit, both axes proceed to the next step.
【#1496(PR)】 push_typ Synchronization when initializing the zero point
0 : Follows #1493.
1 : When #1493=1 and both the primary and secondary axes reach the current limit
when using the stopper method, the droop will be canceled and both axes proceed
to the next step.
【#1501】 polyax
Not used. Set to "0".
【#1505】 ckref2 Second reference position return check
Select whether the check is carried out at the specified position in manual second reference
position return mode upon completion of spindle orientation or at second reference position
return interlock signal.
0: Upon completion of spindle orientation
1: At second reference position return interlock signal
【#1510】 DOOR_H
Not used. Set to "0".
【#1511】 DOORPm
Not used. Set to "0".
【#1512】 DOORPs
Not used. Set to "0".
【#1516】 mill_ax Milling axis name (rotary axis name of polar coordinate interpolation)
Set the name of the rotary axis used in milling interpolation. Only one rotary axis can be set.
---Setting range---
A name for the rotary axis: "C", "B", etc.
【#1517】 mill_C Hypothetical axis command name
Select the hypothetical axis command name for cylindrical interpolation/polar coordinate
interpolation.
This parameter corresponds to the rotary axis name.
0: Y axis command
1: Command rotary axis name.
【#1520(PR)】 Tchg34 Additional axis tool compensation selection
Select axis to carry out the additional axis' tool compensation function for.
0: 3rd axis
1: 4th axis
【#1521】 C_min Minimum turning angle
Set the minimum turning angle of the normal line control axis at the block joint during normal
line control.
---Setting range---
0.000 to 360.000 (°)
【#1522(PR)】 C_axis Normal line control axis
Set the number of the axis for normal line control.
Set a rotary axis No.
---Setting range---
1 to 8
【#1523】 C_feed Normal line control axis turning speed
Set the turning speed of the normal line control axis at the block joint during normal line
control.
Set a value that does not exceed the normal line control axis' clamp speed ("#2002 clamp").
This is valid with normal line control type I.
---Setting range---
0 to 1000000 (°/min)
【#1524】 C_type Normal line control type
Select the normal line control type.
0: Normal line control type I
1: Normal line control type II