Specifications

II Parameters
Base Specifications Parameters
II - 32
【#1287(PR)】 ext23
bit4: Relative coordinate counter display
(M system)
0: Display the position on the program including tool length compensation.
1: Display the position on the program excluding tool length compensation.
(L system)
0: Display the position on the program including tool shape compensation.
1: Display the position on the program excluding tool shape compensation.
bit5: Relative coordinate counter display
(M system)
0: Display the position on the program including tool radius compensation.
1: Display the position on the program excluding tool radius compensation.
(L system)
0: Display the position on the program including nose R compensation.
1: Display the position on the program excluding nose R compensation.
bit6: Workpiece coordinate counter display
(M system)
0: Display the position on the program including tool length compensation.
1: Display the position on the program excluding tool length compensation.
(L system)
0,1: Display the position on the program which excludes tool shape compensation.
This display is also registered to the values of the system variables #5041 and after.
bit7: Workpiece coordinate counter display
(M system)
0: Display the position on the program including tool radius compensation.
1: Display the position on the program excluding tool radius compensation.
(L system)
0: Display the position on the program including nose R compensation.
1: Display the position on the program excluding nose R compensation.
This display is also registered to the values of the system variables #5041 and after.
【#1300(PR)】 ext36
bit7: Spindle synchronization command method
Select the command method for spindle synchronization control.
0: Spindle synchronization control II
(Controlled by PLC)
1: Spindle synchronization control I
(Controlled by G code)
【#1301】 nrfchk Near reference position check method
Select the method to judge the "near reference position".
0: Conventional judging method using command type machine position
1: High-speed judging method using command type machine position
2: High-speed judging method using feedback position
【#1302】 AutoRP Automatic return by program restart
0: Move the system manually to the restart position and then restart the program.
(Automatic return is unavailable.)
1: The system automatically moves to the restart position at the first activation after the
program restarts. (Manual return is also available.)
【#1312】 T_base Tool life management standard number
Set the standard No. for the tool life management.
When the value specified by the T code command exceeds the set value in this parameter,
the set value will be subtracted from the command value, which will be used as tool group
No. for tool life management.
When the value specified by the T code command is equal to or less than the set value, the
T code will be handled as a normal T code and not subjected to tool life management.
When "0" is set in this parameter, the T code command will always specify a group No.
(Valid for M-system tool life management II.)
---Setting range---
0 to 9999
【#1313】 TapDwl Hole bottom wait time
Set the hole bottom wait time of synchronous tap.
Comparing with P command, a greater value will be applied as the hole bottom wait time.
When an in-position check is performed at the hole bottom, the dwell for specified period of
time will be completed after the completion of the in-position check.
(Note) This parameter is enabled when "#1223 aux07 /BIT3, BIT4" is set "1".
---Setting range---
0 to 999 (ms)
【#1314】 TapInp In-position check width for tapping hole bottom(tap axis)
Set the hole bottom in-position check width for synchronous tapping.
The value of "#2224 sv024" is applied when "0" is set.
(Note) This parameter is enabled when "#1223 aux07/bit3,bit4" is set "1".
---Setting range---
0 to 99.999 (mm)