Specifications

II Parameters
Base Specifications Parameters
II - 31
【#1281(PR)】 ext17
bit0: Switch manual high-speed reference position return in synchronous control
Select the movement of synchronized axes in manual high-speed reference position return.
0: Primary and secondary axes start the return synchronizing. Even when one axis
stops at its reference position, the other axis continues moving until it reaches its
reference position.
1: Primary and secondary axes start the return synchronizing, and when the primary
axis stops at the reference position, the secondary also stops. Thus, the relative
position of the primary and secondary is kept.
bit3: Synchronous control operation setting
Select whether or not the positioning of secondary axis automatically aligns with that of
primary axis when the axis subject to synchronous control is changed from servo OFF to
servo ON.
0: The positioning automatically aligns.
1: The positioning does not align.
bit4: Handle feed clamp selection
Select the operation when the speed has been clamped by the clamp speed in handle feed
mode.
0: Clamp the movement speed (compatible with conventional specifications)
1: Clamp the number of handle input pulses
bit5: High-speed synchronous tapping valid
Select whether to enable the high-speed synchronous tapping.
0: Disable
1: Enable
bit6 : Compensation method for external machine coordinate system during
synchronization
Select the method of how to compensate the secondary axis when compensating
external machine coordinate system during synchronization control. The setting of this
parameter will be validated when you select synchronous operation method by the
synchronization control operation method signal.
0: Primary axis and secondary axis are independently compensated.
1: Primary axis' compensation amount is applied to secondary axis.
bit7: Switch automatic high-speed reference position return in synchronous control
Select the movement of synchronized axes in automatic high-speed reference position
return.
0: Primary and secondary axes start the return synchronizing, and when the primary
axis stops at the reference position, the secondary also stops. Thus, the relative
position of the primary and secondary is kept.
1: Primary and secondary axes start the return synchronizing. Even when one axis
stops at its reference position, the other axis continues moving until it reaches its
reference position.
【#1282(PR)】 ext18
bit1: Condition of the reference position reached signal in synchronous control
This parameter switches only conditions of a master axis's reference position return
reached signal in synchronous operation. A secondary axis's signal is output when the
secondary axis reaches the reference position coordinate.
0: A master axis's reference position reached signal is output only when both of the
master and secondary axes reach the reference position coordinate by a reference
position return.
1: A master axis's reference position reached signal is output when the master axis
reaches the reference position coordinate.
【#1284(PR)】 ext20
bit0: Spindle speed clamp check
Select whether to check the spindle speed clamp under the constant surface speed control.
0: Check the spindle speed clamp.
1: Not check the spindle speed clamp.
(Note) This parameter is enabled when the parameter "#1146 Sclamp" is set to "1".