Specifications

II Parameters
Base Specifications Parameters
II - 28
【#1228】 aux12
bit0: Switch coordinate value screen
Set this to switch the coordinate value screens.
0: 80-character screen
1: 40-character screen
bit1: Switch "offset and parameter" screen
Select to switch the "offset and parameter" screen to the parameter screen.
0: Display the "offset and parameter" screen.
1: Display the "parameter" screen.
bit2: Switch data protection in data transmission mode
Select the data protection range in data transmission mode.
0: Enable the protection in both sending and receiving data.
1: Enable the protection only in sending data.
bit4: Select operation error or stop code
Select whether to handle the block start and cutting start interlocks as stop codes.
0: Operation error
1: Stop code
bit5: Select constant surface speed coordinates
Select the coordinate system for constant surface speed control.
0: Workpiece coordinate
1: Absolute value coordinate
bit6: Switch relative values displayed
Select whether to preset the relative coordinates with counter preset (G92).
0: Preset the relative coordinates.
1: Not preset the relative coordinates.
bit7: Protection with manual value command
Select whether to protect a manual value command.
0: Not protect. (Same as conventional)
1: Protect.
【#1229】 set01
bit0: Subprogram interrupt
Select the type of the user macro interrupt.
0: Macro type user macro interrupt
1: Sub-program type user macro interrupt
bit1: Accurate thread cutting E
Select what the address E specifies in inch screw cutting.
0: Number of threads per inch
1: Precision lead
bit2: Radius compensation type B (for M system only)
Select the method of the arithmetic processing for the intersection point when the start-up or
cancel command is operated during radius compensation.
0: The processing does not handle the start-up or cancel command block: handle the
offset vector in the direction vertical to that of the command instead.
1: The processing is executed for the intersection point between the command block
and the next block.
bit2: Nose R compensation type B (for L system only)
Select the method of the arithmetic processing for the intersection point when the start-up or
cancel commands are operated during nose R compensation.
0: The processing does not handle the start-up or cancel command block: handle the
offset vector in the direction vertical to that of the command instead.
1: The processing is executed for the intersection point between the command block
and the next block.
bit3: Initial constant surface speed
Select the initial state after the power-ON.
0: Constant surface speed control cancel mode
1: Constant surface speed control mode
bit4: Synchronous tap
Select the operation when ",R" is omitted in G74/G84 tapping cycle.
0: Asynchronous tap
1: Synchronous tap
bit6: Grid display selection
Select the grid display type on the servo monitor screen during the dog type reference
position return.
0: Distance between dog OFF and basic point (including a grid mask amount)
1: A value given by reducing a grid mask amount from the distance between dog OFF
and basic point