Specifications
Table Of Contents
- Front cover
- Trademarks
- Contents
- Remedy and measure after a report of error
- I Alarms
- 1. Operation Errors (M)
- 2. Stop Codes (T)
- 3. Servo/Spindle Alarms (S)
- 4. MCP Alarms (Y)
- 5. Safety Observation Alarms (Y)
- 6. System Alarms (Z)
- 7. Absolute Position Detection System Alarms (Z7*)
- 8. Emergency Stop Alarms (EMG)
- 9. Auxiliary Axis Operation Errors (M)
- 10. CNCCPU-side Safety Sequence Alarm(U)
- 11. Multi CPU Errors (A)
- 12. Network Errors (L)
- 13. Program Errors (P)
- II Parameters
- 1. Machining Parameters
- 2. Base Specifications Parameters
- 3. Axis Specifications Parameters
- 4. Servo Parameters
- 5. Spindle Parameters
- 6. Multi-CPU Parameters
- 7. FL-net Parameters
- 8. DeviceNet Parameters
- 9. Machine Error Compensation Parameters
- 10. PLC Parameters
- 11. Macro List
- 12. Position Switches
- 13. PLC Axis Indexing Parameters
- III PLC Devices
- Revision History
- Back cover
II Parameters
Base Specifications Parameters
II - 23
【#1211】 FHtyp Feed hold stop type
Select the type of the external signal used for feed hold.
0: Disable the external signal.
1: Enable the external signal (contact A)
2: Enable the external signal (contact B)
---Setting range---
0 to 2
【#1212】 FHno Feed hold external signal device
Set the device No. (X**) used to input the feed hold signal.
---Setting range---
000 to 2FF (hexadecimal)
【#1216】 extdcc External deceleration level
Set the upper limit value of the feedrate when the external deceleration signals are enabled.
This parameter is valid when "#1239 set11/bit6" is set to "0".
---Setting range---
1 to 1000000 (mm/min)
【#1218】 aux02
bit3: Parameter input/output format
Select the parameter input/output format.
0: Type I
1: Type II (related to "#1218 aux02/bit5")
bit4: External workpiece coordinate offset tool number selection
Select the R register that contains the tool number used for automatic calculation when
measuring the coordinate offset of an external workpiece.
0: Follow the setting of "#1130 set_t".
1: Use the tool number indicated by user PLC.
bit5: Parameter I/O II spindle specification address
Select the spindle specification address of parameter I/O type II.
0: C
1: T
This parameter is also applied to the spindle specification address for input and verification.
(Note) This parameter is valid only for parameter I/O type II (when "#1218 aux02/bit3" is set
to "1").
bit6: Set No. valid when program input
Select which program No. is applied when inputting programs in "#1 MAIN PROGRAM" on
Data I/O screen.
0: The No. in the input data
1: The No. set in the data setting area
bit7: Input by program overwrite
Select the operation when the program to be input in "#1 MAIN PROGRAM" on Data I/O
screen, has already been registered.
0: An operation error (E65) occurs.
1: Input by overwrite.