Specifications

II Parameters
Base Specifications Parameters
II - 22
bit 0: Group 1 Move G modal initialization
The H code indicates the tool length offset number, and the D code indicates the tool radius
compensation number.
When bit 18 is set to ON, the H and D codes and group 8 G modal are retained.
When bit 7 is set to ON, the H code and group 8 G modal are retained.
<Description of bits for L system>
bit 1F: (Not used)
bit 1E: (Not used)
bit 1D: (Not used)
bit 1C: (Not used)
bit 1B: (Not used)
bit 1A: (Not used)
bit 19: Spindle clamp rotation speed initialization
bit 18: (Not used)
bit 17: (Not used)
bit 16: (Not used)
bit 15: (Not used)
bit 14: Group 15 Facing turret mirror image initialization
bit 13: Group 20 2nd spindle control modal initialization
bit 12: (Not used)
bit 11: Group 18 Balance cut initialization
bit 10: Group 17 Constant surface speed control command modal initialization
bit F: (Not used)
bit E: (Not used)
bit D: (Not used)
bit C: Group 13 Cutting modal initialization
bit B: Group 12 Workpiece coordinate system modal initialization
bit A: (Not used)
bit 9: Group 10 Fixed cycle return command modal initialization
bit 8: (Not used)
bit 7: (Not used)
bit 6: Group 7 Nose R compensation modal initialization
bit 5: Group 6 Inch/metric modal initialization
bit 4: Group 5 Feed G modal initialization
bit 3: Group 4 Barrier check modal initialization
bit 2: Group 3 Absolute/incremental command modal initialization
bit 1: Group 2 Plane selection modal initialization
bit 0: Group 1 Move G modal initialization
1F 1E 1D 1C 1B 1A 19 18 17 16 15 14 13 12 11 10
0000 00
*
0 000
*
*
0
**
FEDC BA98 7654 3210
0
0
0
**
0
*
00
*** ****