Specifications

II Parameters
Base Specifications Parameters
II - 21
【#1210】 RstGmd Modal G code reset
Select whether to initialize G code group modals and H and D codes, which corresponds to
bits as follows, when the system is reset.
0: Initialize.
1: Not initialize.
<Description of bits for M system>
bit 1F: (Not used)
bit 1E: (Not used)
bit 1D: (Not used)
bit 1C: (Not used)
bit 1B: (Not used)
bit 1A: (Not used)
bit 19: Spindle clamp rotation speed initialization
bit 18: H, D codes initialization
bit 17: (Not used)
bit 16: (Not used)
bit 15: (Not used)
bit 14: (Not used)
bit 13: Group 20 2nd spindle control modal initialization
bit 12: Group 19 G command mirror modal initialization
bit 11: (Not used)
bit 10: Group 17 Constant surface speed control command modal initialization
bit F: (Not used)
bit E: Group 15 Normal line control modal initialization
bit D: (Not used)
bit C: Group 13 Cutting modal initialization
bit B: Group 12 Workpiece coordinate system modal initialization
bit A: (Not used)
bit 9: Group 10 Fixed cycle return command modal initialization
bit 8: (Not used)
bit 7: Group 8 Length compensation modal initialization
bit 6: Group 7 Radius compensation modal initialization
bit 5: Group 6 Inch/metric modal initialization
bit 4: Group 5 Feed G modal initialization
bit 3: (Not used)
bit 2: Group 3 Absolute/incremental command modal initialization
bit 1: Group 2 Plane selection modal initialization
1F 1E 1D 1C 1B 1A 19 18 17 16 15 14 13 12 11 10
0000 00
**
0000
****
FEDC BA98 7654 3210
0
*
0
**
0
*
0
****
0
***