Specifications
Table Of Contents
- Front cover
- Trademarks
- Contents
- Remedy and measure after a report of error
- I Alarms
- 1. Operation Errors (M)
- 2. Stop Codes (T)
- 3. Servo/Spindle Alarms (S)
- 4. MCP Alarms (Y)
- 5. Safety Observation Alarms (Y)
- 6. System Alarms (Z)
- 7. Absolute Position Detection System Alarms (Z7*)
- 8. Emergency Stop Alarms (EMG)
- 9. Auxiliary Axis Operation Errors (M)
- 10. CNCCPU-side Safety Sequence Alarm(U)
- 11. Multi CPU Errors (A)
- 12. Network Errors (L)
- 13. Program Errors (P)
- II Parameters
- 1. Machining Parameters
- 2. Base Specifications Parameters
- 3. Axis Specifications Parameters
- 4. Servo Parameters
- 5. Spindle Parameters
- 6. Multi-CPU Parameters
- 7. FL-net Parameters
- 8. DeviceNet Parameters
- 9. Machine Error Compensation Parameters
- 10. PLC Parameters
- 11. Macro List
- 12. Position Switches
- 13. PLC Axis Indexing Parameters
- III PLC Devices
- Revision History
- Back cover
II Parameters
Base Specifications Parameters
II - 20
【#1206】 G1bF Maximum speed
Set a cutting feedrate when applying pre-interpolation acceleration/deceleration.
---Setting range---
1 to 1000000 (mm/min)
【#1207】 G1btL Time constant
Set a cutting feed time constant when applying pre-interpolation acceleration/deceleration.
---Setting range---
1 to 5000 (ms)
【#1208】 RCK Arc radius error compensation factor
Set a coefficient for arc radius error compensation.
An arc radius error compensation amount can be increased or decreased between -60.0
and +20.0%.
---Setting range---
-60.0 to +20.0 (%)
【#1209】 cirdcc Arc deceleration speed
Set the deceleration speed at the arc entrance or exit.
---Setting range---
1 to 1000000 (mm/min)
G1btL
G1bF
Time
Speed