Specifications

II Parameters
Base Specifications Parameters
II - 11
【#1078】 Decpt2 Decimal point type 2
Select the increment of position commands that do not have a decimal point.
0: Minimum input command unit (follows "#1015 cunit")
1: 1mm (or 1inch) unit (For the dwell time, 1s unit is used.)
【#1079】 F1digt Validate F1 digit
Select the F command method.
0: Direct numerical command (command feedrate during feed per minute or rotation)
1: 1-digit code command (feedrate set with “#1185 spd_F1” to “#1189 spd_F5”)
【#1080】 Dril_Z Specify boring axis (for M system only)
Select a fixed cycle hole drilling axis.
0: Use an axis vertical to the selected plane as hole drilling axis.
1: Use the Z axis as the hole drilling axis regardless of the selected plane.
【#1081】 Gmac_P Give priority to G code parameter
Select the G code priority relationship during the macro call with G command.
0: Priority is on G code used in the system
1: Priority is on registered G code for call
【#1082】 Geomet Geometric
Select the type of geometric to use.
0: Not use
1: Use only geometric I
2: Use geometric I and IB
With geometric, specific address codes are used for exclusive meanings. Thus, if A or C is
used for the axis name or 2nd miscellaneous command code, the A used for the axis name
may function as the geometric's angle designation. Pay special attention to axis names,
etc., when using this function.
【#1084】 RadErr Arc error
Set the tolerable error range when the end point deviates from the center coordinate in the
circular command.
---Setting range---
0 to 1.000 (mm)
【#1085】 G00Drn G00 dry run
Select whether to apply dry run (feed at manual setting speed instead of command
feedrate) to the G00 command.
0: Not apply to G00. (move at rapid traverse rate)
1: Apply to G00. (move at manual setting speed)
【#1086】 G0lntp G00 non-interpolation
Select the G00 travel path type.
0: Move linearly toward the end point. (interpolation type)
1: Move to the end point of each axis at the rapid traverse feedrate for each axis. (non-
interpolation)
(Note) If this parameter is set to "1", neither of the following functions will be available: rapid
traverse constant inclination acceleration/deceleration.
【#1087】 G96_G0 Constant surface speed control by rapid traverse feed command
Select how to handle the surface speed for the G00 command when using the constant
surface speed control function.
0: Calculate the surface speed constantly even during G00 movement
1: Calculate the surface speed at the block end point in the G00 command
【#1088】 G30SL Disable G30 soft limit
Select how to handle the soft limit during G30 (2nd reference position return).
0: Enable
1: Disable
【#1089】 Cut_RT
Not used. Set to "0".
【#1090】 Lin_RT
Not used. Set to "0".
【#1091】 Mpoint Ignore middle point
Select how to handle the middle point during G28 and G30 reference position return.
0: Pass the middle point designated in the program and move to the reference position.
1: Ignore the middle point designated in the program and move straight to the reference
position.
【#1092】 Tchg _A Replace tools for additional axis
Select the movement of the additional axis at the tool change position return command.
0: The additional axis will not move
1: After the standard axis returns, the additional axis will also return to the tool change
position