User`s manual

BD2-2860 User’s Manual
CITIZEN
59
ESC v (Serial Interface Only)
[Function] Transmitting the printer status (Serial Type)
[Code] <1B>H<76>H
[Outline] Current printer status is transmitted.
[Caution]
• Status sent out consists of 1 byte whose content is as in the table below.
• In DTR/DSR control, after revertible state of the host (DSR signal being in SPACE
state) is confirmed, only 1 byte is transmitted. In XON/XOFF control, DSR signal state
not being confirmed, only 1 byte is transmitted.
• In DTR/DSR control, when the host is in unrespectable state (DSR signal being in
MARK state), it waits until receptacle state is created.
• In paper end (paper near end) status, this command may be unrespectable state due to
BUSY state.
Remarks. This command is valid only for serial interface model.
ValueBit Function
01
0 Not defined
1 Not defined
2 Paper end With paper Without paper
3 Not defined
4 Not used Fixed to 0
–
5 Not defined
6 Not defined
7 Not defined
[Sample Program]
OPEN "COM1: N81NN" AS #1;
PRINT #1, CHR$ (&H1B) + "v”;
A$ = INPUT$ (1, #1);
CLOSE #1