User`s manual

BD2-2860 User’s Manual
CITIZEN
25
8.2 Operation Errors
(1)Error types
Error Description
No paper The printing paper set is not set
Head –up The head-up lever is at its up position
VH voltage error A VH voltage is beyond its allowable range (4.2 to 8.5V)
Head temperature error A head temperature is less than 0°Cor65°C or higher.
Cutter lock
(ACS-220-5V)
When driving the cutter, the cutter is locked due to an external factor (Paper jam,
etc.).
Note 1) The 8.5V upper-limit voltage for VH voltage error is only an assumptive voltage just after charging the
battery when using the battery power. It cannot be normally used. A normalmaximum voltage is 7.2V.
(2) External signal outputs
Interface Connector (CN3)
Pin No. Signal Name Remarks
20 ERROR LED output. For a blinking (Lighting) pattern, see 8.3 Error Indication.
21 PE OUT LED output. This is always output at the time of no paper.
22 DTR Serial interface
27 BUSY Parallel interface
37 PE Parallel interface
38 FAULT Parallel interface
(3) Resetting methods
Error Resetting Method
No paper Set the paper. See Note 1.
Head –up Bring down the head-up lever.
VH voltage error Set to a voltage within the allowable range (4.2 to 8.5V) and turn on the power
again. Alternatively, activate the Pin19 (LFSW) of the CN3(interface connector).
Head temperature error At the lower limit (less than 0°C), printing becomes operational at 0°C higher.
At the upper limit (65°C or higher), it become operational at 60°Corlower.
Cutter lock
(ACS-220-5V)
Eliminate paper jam and activate the Pin19(LFSW) of the CN3(Interface
Connector) or turn on the power again.
Note 1) When auto loading has not been selected with the function selection jumper(J4), set the paper manually.
When it has been selected, the auto loading function is enabled to facilitate replacement of the paper.
Note 2) The 8.5V upper-limit voltage for VH voltage error is only an assumptive voltage just after charging the
battery when using the battery power. It cannot be normally used. A normal maximum voltage is 7.2V.