User`s manual

BD2-2860 User’s Manual

CITIZEN

CAUTION:

1. For LED of ERROR and PE, there is a resister of 330Ω on the circuit side to make current

value 10mA.

Please use LED which its voltage is approx. 2V. LED over 10mA may break a control board.

2. Control circuit requires power supply only for one pin of each VCC and GND.

However, Operation voltage is to be supplied to all of pin for safety use.

3. Serial interface equips a driver and receiver of RS-232C, make sure to use it at RS-232C

level.

4. RESET terminal is pulled up by 3.3KW. Make sure to make this terminal NC, when this

terminal is not used.

5. LF-SW input circuit is as below.

3.4 CN4 Connector for Paper Cutter

Pin No. Signal Name I/O Function

1 M + Output Cutter motor operational signal M +

2M– Output Cutter motor operational signal M –

3 GND – GND

4 SW Input Cutter switch input signal

Using Connector : 5207-0410A (Molex)

Note ) Use the specified Paper Cutter(Model Name : ACS-220-5V)