Specifications

38
7.3
Memory Switches
Memory switch is a generic name for the following:
Memory switches MSW1, MSW2, and MSW3
Customize value
Serial Interface Communication Conditions
1) Memory switches MSW1, MSW2, and MSW3
Memory switch setting table
No. Function OFF ON
MSW1-1 Power ON notice setting ● Enable Disable
MSW1-2 Input buffer ● 4K bytes 45 bytes
MSW1-3 Busy condition ● Full/Off line Buffer full
MSW1-4 Receive error character ● Character “?” Disable
MSW1-5 CR mode ● Disable Enable
MSW1-6 Reserved ● Fixed ―
MSW1-7 DSR signal selection ● Disable Enable
MSW1-8 Reserved ● Fixed ―
MSW2-1 Reserved ― ● Fixed
MSW2-2 Reserved ― ● Fixed
MSW2-3 Buffering ● Disable Enable
MSW2-4 Full digit printing ● Line feed WaitData
MSW2-5 Head Down restore * ● Next Top
MSW2-6 Reserved ― ● Fixed
MSW2-7 Reserved ● Fixed ―
MSW2-8 Reserved ● Fixed ―
MSW3-1 Auto Cutter recovery ● L/F Enable L/F Disable
MSW3-2 Reserved ● Fixed ―
MSW3-3 Parallel Reset ● Reset Ignored
MSW3-4 Reserved ● Fixed ―
MSW3-5 Reserved ● Fixed ―
MSW3-6 Reserved ● Fixed ―
MSW3-7 Reserved ● Fixed ―
MSW3-8 Head Up in printing * ● Automatic recovery Recoverable error
● Default (factory setting)
* When LT2221/2321 is used, function for Platen Close/Platen Open is applied.