Specifications
27
5.3.3 Memory Switch Setting Mode
1) Settable memory switch
MSW1、MSW2、MSW3
2) Starting memory switch setting mode
With paper set and Head Up (or Platen Open), turn the power on while pressing and holding
the FEED switch and then press the FEED switch twice, set Head Down (or Platen Close) to
start the setting mode.
After the setting mode is started, the guidance of setting content and operation method is
printed.
3) Selecting memory switch
By pressing FEED SW shortly (less than 500 ms), the memory switches to be set is selected in
the following order.
In doing so, the status of selected memory switch is printed. However, when f is selected,
the verification of flash memory writing is printed.
(1) MSW1
(2) MSW2
(3) MSW3
(4) Recording / Initialization of the setting
* By pressing the FEED switch long (2s or more) when c to e is selected, setting the
selected memory switch is started. (Goes to the following 4) Setting memory switch.)
* By pressing the FEED switch long when (4) is selected, current memory switch settings are
all written into the flash memory and Reset operation is carried out. (Goes to the
following 5) Terminating memory switch setting mode.)
By pressing the FEED switch long with Head Up (or Platen Open) when (4) is selected, a reset
operation is executed with current memory switch settings discarded and factory setting
restored. (Goes to the following 5) Terminating memory switch setting mode.)
4) Setting memory switch
(1) Print the status of bit which is currently set.
(2) Pressing the FEED switch short (less than 500 ms) causes the selected bit to be inverted.
Here, if the bit is ON, error LED lights.
(3) Pressing the FEED switch long (more than 2s) causes current bit to be saved. If any
change occurs, the status of the bit is printed.
Setting the following bits is started.
The order of change of bit is shown below.
Bit 0 → Bit 1 →…→ Bit 6 → Bit 7 → Bit 0 →…
(4) The setting is terminated with Head Up (or Platen Open). Then by Head Down, current
status of memory switch is printed and returns to 3) Selecting memory switch.
5) Terminating memory switch setting mode
After setting, the settings are saved and initializing operation (Reset) is carried out and
normal printable condition is restored.