User`s manual

BD2-1220/1221 User’s Manual
22
8.2 Error Details
Memory Check Error: Activated if an error is detected at power on.
Head Up: Activated if the print head is raised with the Head-Up lever. The printer stops
printing and generates an ERROR signal.
Head Overheat: Activated if the print head temperature exceeds approx. 65°C, causing the
printer to stop printing and generating an ERROR signal. The printer
automatically resumes printing when the head temperature drops below
approx. 60°C.
Paper Near End: Activated if the paper is running out. Then generates a PEOUT signal.
Paper End: Activated if the paper end sensor senses the end of the paper, generating a
PEOUT signal and causing the printer to stop printing.
Cutter Motor Lockup: Activated if the cutter position sensor fails to detect cutter On/Off actions
within a prescribed time period, generating an ERROR signal and causing
cutter and printer operation to stop.
Low Voltage: Activated if the drive voltage on the control board drops below a certain
threshold. If this error occurred, immediately shut off the control board.
High Voltage: Activated if the drive voltage on the control board exceeds a certain threshold.
If this error occurred, immediately turn off the control board.
Waiting for Macro: Activated if a macro function is executed by a macro command, generates an
ERROR signal and the printer resumes printing (macro print) when the LF-SW
signal is set to Low.
* The dedication (activation) conditions for the Paper Near End and Paper End signals can be
changed with printer control commands. (For more details, read the Command Reference Manual.)