Instruction manual

Quarter Masters
3 Player Game to Mutha System
You will need 3 of the “Generic Isolator” PCB for a full installation. If you are not going to be
remote collecting, you can get away with 2.
You must have all 3 Fledgling/Slave boards running from the same power supply and that
power supply should not have a common ground to the game boards. A 5VDC wall
transformer capable of 500mA or more should be adequate and easy to install.
Before going any further, the Fledgling should all be installed and functioning. You can check
that by using the buttons on the Fledglings to get bookkeeping and status reports.
The following connections will need to be made for the cash out/collect of the Quarter Masters
board to work. On the Opto boards Pin 1 is the left pin as looking at the board edge on, and
there is a square pad on the bottom of the PCB for pin 1. On the Fledgling boards the same
thing applies, and the connector number (JX) is always next to Pin 1.
On the Opto board, cut off the 3 shorting jumpers near the Input connector and add 3 jumpers
to the side that says Outputs. Any small piece of wire will do.
Generic Isolator # 1
Input Connector Output Connector
1 Game 1 Out meter + 1 Fledgling 1 J1 Pin 6
2 Game 1 Out meter - 2 N/U
3 Game 2 Out meter + 3 N/U
4 Game 2 Out meter - 4 Fledgling 3 J1 Pin 1
5 Game 3 Out meter + 5 N/U
6 Game 3 Out meter - 6 Fledgling 2 J1 Pin 1
7 N/U 7 N/U
8 N/U 8 Fledgling 1 J1 Pin 1
On the Fledglings, turn all switches on DIP Switch 1 to off, and collect credits from each
station. You should get a print out from each unit. The amounts might not be correct, but they
should print the number of credits from each station.
28