Instruction manual

Mutha Goose
Dailies Program Information
Overview:
The dailies program just creates a separate set of running books that can be printed and
cleared separately from each other. This allows the location to access one set of books for in
house use and the main books can be protected by the key and only accessed during a collection.
Naturally, there are other scenarios that another set of books may come in handy for.
Setup Information :
You should be using Gaggle V1.26 or better, Fledgling V1.26 or better and the base unit
should have V1.58 or better installed. These ICs are available from RKS if you need to upgrade
any of your units. Be aware that the memory of the units will be cleared when upgrading to the
dailies programs, so you should do a full bookeeping dump before the upgrade. The best time is
during a location collection after all the bookeeping and money have been settled and verified.
If the base unit is being upgraded you will need to add a push button switch for the dailies. We
recommend a button similar to the existing switches, which are available at Radio Shack, and
that the dailies button be placed 2 inches below the Summary Reprint button. (See Photo)
The Daily button should get its’ ground from the Summary Reprint button and the other
connection should go to pin 3 (counting left to right) of the 6 pin panel connector. (See Photo)
This will allow the dailies to be printed and cleared without the need for a key, while keeping the
main books protected.
Change all the ICs at once and power up the games first. Make sure that they all power up
with flashing status LEDs. Once those have been verified, power up the base unit. It should
power up and print a power up ticket. You may be asked to press buttons 1 and 4 inside the base
unit to clear the RAM, do so if requested.
9