User's Manual Printer PROdot 350

- 23 -
Chapter 6
Passbook Printing
Passbook Printing Configuration
To configure the printer to handle vertical passbooks, the following items in
the control panel setup menu must be changed:
Head Gap This determines the operation of the media gap sensor.
There are 5 options:
Auto One detects the paper thickness when the
printer starts printing each page
Auto All detects the paper thickness on each line
printed
Fix Pos Fixes the head gap to a particular value as
determined by the “Gap Pos” value
Passbook1 is used for measuring the length of the
passbook automatically
Passbook2 is used for presetting the length of the
passbook using the “PB Length” value.
Gap Pos. This selects the fixed heap gap value when using the “Fix
Pos” Head Gap.
PB Length This sets the fixed passbook length in values from 2
inches to 4 inches, in one-sixth inch increments.
Cross Page When enabled, causes the printer to increase the heap
gap to the maximum value while the printer skips over the
perforations between continuous paper sheets.
Skew Correct Enables or disables the shutter mechanism operation for
straightening media not correctly inserted.