User's Manual

4. In case the phone number is a long-distance number, add a long distance
number by press 0 or 1.
5. If you want to dial a number without area code, press 7 to dialing out last
seven number, or press 8 to dialing out last eight number.
TO EDIT PHONE NUMBER WITH NAME
1. In the stand by mode, press STORE button, the LCD will show: “XX
memories”.
2. Press SET button to enter edit phonebook entry.
3. Press FLASH button to delete any incorrect digits and then enter the
correct number using the keypad
4. Press STORE button to enter edit letter.
5. Press FLASH button to delete any incorrect characters, then re-enter the
correct characters using the keypad.
DELETING A PHONEBOOK ENTRY
1. In the stand by mode, press STORE button, the LCD will show: “XX
memories”.
2. Press UP or DOWN button to enter review phone book entry.
3. Press FLASH twice to delete current phonebook entry.
TO EARSE NAME BOOK RECORD
1. In the stand by mode, press STORE button, the LCD will show: “XX
memories”.
2. Press FLASH twice will delete all phonebook entry.
PROBLEM SOLVING
Problem solving section
For your assistance, we have listed below a few common problems.
Phone does not work, check the following:
Base unit is plugged into power source.
Handset is charged.
Tone/pulse switch is in the right position.
Line cord is plugged into the jack.
Range of phone limited, check the following:
Antenna on base unit is raised.
Base unit is centrally located in your residence.
Base unit is not located near appliances.
No dial tone, check the following:
Telephone plug is connected to the telephone line.
If you had a power failure or had unplugged the base unit, replace the handset on the base unit for
2 to 5 seconds to reset the system.
Received signal flutters or fades, check the following:
Battery pack in handset is fully charged.
Handset is not too far from the base unit.
Antenna on base unit is raised.
Interference on reception, check the following:
Noise may be picked up from electrical products in the home or electrical storms. Generally, this
noise is a minor annoyance and should not be interpreted as a defect in your system.
Choose an alternate channel using the CH button on the handset.
Excess static, check the following:
1. Check to see that the antenna is not touching another metal object.
2. Raise the antenna.
If after pressing the TALK button, you receive three beeps and no dial tone, check the
following:
1. Reset the handset by placing it on the base unit for 2-5 seconds.
Note: If no telephone in the house are working, disconnect one set at a time to verify that none of
the phones are causing the problem. If you still have a problem after doing this and you telephone
still does not work, please contact you local phone company.
11 12