Manualshelf

User's Manual

ManualsBrandsCiti Sound Electronic ManualsElectronics2.4GHz 40 Channel Analog Modulation Cordless Phone
123456789
telephone jack. Insert the free end of the line cord through the hole of the
mounting bracket.
2. Insert the hooks of the mounting bracket into the matching slots the base
unit (as shown below). Then slide the mounting bracket into place. Plug the
free end of the short telephone line cord into the modular wall jack.
3. Align the upper keyhole on the mounting bracket with the upper stud of the
wall plate, so that the opening end of the mounting bracket matches the
lower stud, then pull the base unit down until securely seated.
Figure 3
SETUP THE TELEPHONE
1’048’576 DIGITAL CODE SECURITY
Many cordless telephone operate similarly and on the same frequency without
digital code security. Another cordless Handset could make calls using your
Base and telephone line. Therefore to avoid any unauthorized calls through your
Base, a Digital code feature was added to your Cordless phone. This Digital
Code is shared only between the Handset and Base. The code is set
automatically when you first use the phone.
Reset Your Security Code ---Important Steps!
1. Remove the Handsets unit from the base then press and hold down PAGE
button on the Base unit about 5 second.
2. Press CODE button on the Handset.
3. When you hearing continuous beep tone, the Digital Code is reset randomly
to one of 1’048’576 codes.
4. Release the PAGE button on Base unit.
SET LCD CONTRAST
Press SET button and then press the “2” button, LCD will display: “CONTRAST
ADJ”. Press UP or DOWN buttons to set desired contrast level and press SET
button to confirm and exit setting.
SET RINGER ON/OFF
1. Press SET button and then press the 3 button, “RING ON” or “RING OFF”
will appear on the LCD display.
2. Press UP and DOWN to switch the RING ON or RING OFF.
3. Press SET button to confirm.
SET UP THE TIME & CLOCK
1. Press SET button and then press the “4” button, LCD will show: “SET
TIME”, the month icon will be blinking.
2. Press UP and DOWN to set the correct month.
3. Press SET button to confirm and shift to date setting.
4. Press UP and DOWN to set the correct date.
5. Press SET button to confirm and shift to hour setting.
6. Repeat above operation to set hour and minute.
RECEIVER VOLUME HIGH/NORM SELECTION
The volume selector should be set to the Norm position. But when you want to
hear some undertone talk, slide the selector to High position.
7 8