User guide

6
Connecting your C4110 Phone
Follow the following steps to connect the C4110 IP Phone
Step1: Pull upward the stand through the slots on the base, remove the stand.
Step2: Connect one end of the handset cord to the handset jack with symbol on the
telephone base and connect the other end of the handset cord to the handset. Route the
cord through the cord guide channel.
Slide the stand back until it clicks into the lock position.
Step3: Connect one end of the supplied Ethernet cable with RJ45 connector to the
Ethernet port on the telephone base and connect the other end of the cable to an IP
voice network jack through the catch on the telephone stand.
Step4: If you are connecting your PC Ethernet through the phone, connect one end of
the PC Ethernet cable to your phone using the RJ45 connector marked with the
symbol on the telephone base, and thread it through the catch on the stand. Connect
the other end to the LAN port on your PC.
Step5: Plug AC power adapter into the base of the telephone, and plug the adapter
into the nearest AC power outlet. If you are using PoE (Power over Ethernet), the AC
power adapter is not needed.
Step6: To wall mount the C4110 IP Phone, you need to remove the stand and reverse
it, then slide it back. Use the wall mounting holes on the stand to attach the IP Phone
on the wall.