Specifications

SECTION IV
OPERATING INFORMATION
MODEL 560
BEFORE TAKEOFF
1. Flaps - SET.
2. Speed Brakes - RETRACTED.
3. Trims - (3) SET FOR TAKEOFF.
4. Anti-ice/Deice - AS REQUIRED. Check anti-ice and deice systems when icing conditions are
anticipated.
CAUTION
f IF ANTI-ICE SYSTEMS ARE TO BE USED FOR TAKEOFF AND GROUND
AMBIENT TEMPERATURE IS BETWEEN 0°C AND 10°C, CLOSE THE R
WINDSHIELD BLEED AIR MANUAL VALVE FOR TAKEOFF. THIS WILL ENSURE
ADEQUATE BLEED AIR TEMPERATURE REGULATION TO THE PYLON PRE-
COOLERS. AFTER THE THROTTLES HAVE BEEN REDUCED TO CLIMB
POWER, THE R WINDSHIELD BLEED AIR KNOB MAY BE OPENED AS
DESIRED.
f DO NOT OPERATE DEICE BOOTS WHEN AMBIENT AIR TEMPERATURE IS
BELOW -40°C (-40°F).
f LIMIT GROUND OPERATION OF PITOT STATIC HEAT TO TWO MINUTES ON
WITH TWO MINUTES OFF BETWEEN CYCLES TO PRECLUDE SYSTEM
DAMAGE.
5. Crew Briefing - COMPLETE.
---------------------------------------------CLEARED FOR TAKEOFF-------------------------------------------
6. IGNITION Switch - ON.
7. PITOT & STATIC Heat - ON.
8. Exterior Lights - AS REQUIRED.
NOTE
Do not operate the anti-collision lights in conditions of fog, clouds or haze as the
reflection of the light beam can cause disorientation or vertigo.
9. Transponder/TCAS - TA/RA.
10. Radar - ON.
11. Engine Instruments - CHECK.
12. Annunciator Panel - CHECK.
NOTE
Generally, in non-icing conditions, all annunciators should be extinguished except
GND IDLE.
TAKEOFF
1. Throttles - SET TAKEOFF N
1
.
2. Engine Instruments - CHECK.
3. Brakes - RELEASE.
4. Throttles - Trim N
1
setting as required by 80 KIAS.
I 4-12 Configuration AB 56OMB-01