Specifications

SECTION IV
MODEL 560 OPERATING INFORMATION
BEFORE TAXI (Continued)
b. Radio Altimeter - SET.
c. Altimeters - SET and CROSS CHECK.
d. Heading - CROSS CHECK.
e. Communication Frequencies - SET.
f. Navigation Frequencies - SET.
g. Course - SET.
h. Autopilot (at pilot’s discretion) - ENGAGE, PUSH left AP TRIM DISC switch, verify autopilot
disconnects and chime sounds. Repeat using right AP TRIM DISC switch.
9. AC Inverter Switch - CHECK INV 1 and INV 2. VERIFY ATT flags on either PFD remain out of
view and failed inverter is annunciated; then, Inverter Switch - NORM.
10. COCKPIT VOICE RECORDER TEST Button - PUSH and HOLD for 5 seconds, verify test light
illuminates.
11. Annunciators - CHECKED.
NOTE
The antiskid system must be turned on and the self-test sequence completed
(antiskid annunciator light out) while the airplane is stationary. If the airplane is taxiing
when the antiskid system is actuated, the antiskid test sequence will not be
completed successfully and the antiskid will not be operational during takeoff.
12. Avionics Cooling Fans - CHECK OPERATING.
13. Passenger Advisory Lights - PASS SAFETY.
14. Pilot and Copilot Foot Warmers - OPEN (Down).
TAXI
1. Brakes - CHECK.
CAUTION
IF, DURING TAXI, A NORMAL BRAKE PEDAL - NO BRAKING CONDITION IS
ENCOUNTERED, OPERATE THE EMERGENCY BRAKE SYSTEM AS REQUIRED.
CORRECT PRIOR TO FLIGHT.
2. Nosewheel Steering - CHECK.
NOTE
When taxiing in strong crosswinds, differential braking may be required to supplement
nosewheel steering.
3. Thrust Reversers - CHECK.
a. Deploy Thrust Reversers, check sequencing and timing of lights.
b. Select STOW EMER, check sequencing and timing of lights.
c. Stow Thrust Reversers, check ARM lights remain illuminated.
d. Deselect STOW EMER, verify all Thrust Reverser lights extinguished.
4. Takeoff Speeds and Distance - SET.
a. Confirm V
1
, V
R
, V
2
and V
ENR
displayed on PFD.
5. Takeoff N
1
- SET.
a. Obtain takeoff N
1
from Section IV, Performance, or abbreviated checklist.
I 56OMB-01 Configuration AA 4-11