W10 Manual Please read this manual carefully before using device.
ATTENTION This is a Class A product. In a living environment, this product may cause radio interference. In this case, the user may need to take adequate measures. Replacing with error battery may cause explosion! Replaced old battery should be handed over to the repairman for disposal! Do not put them into fire! There is a Lithium battery in the device. Its voltage will decline if it is not turned on for long time. It will even stop working if the battery volume was exhausted.
Kindly find below items when opening carton ITEM LIST Device 1 unit Thermal pape 1 roll Adaptor 1 pc Power core 1 pc Manual 1 pc Desiccative 2 bags Name Configuration CPU Intel Celeron J3455,1.5GHz quad RAM 4GB ROM 64GB,Max 256GB TF Storage Max 128GB OS Windows 10 32/64 Bit Display 1024*768 Touch Screen Capacitive multi-touch Bluetooth V4.2 Speaker Stereo 2W Indicator light Programmable orange and blue WiFi Name Remark IEEE 802.11 b/g/n 2.
Printer 80mm Thermal printer PrintingSpeed MAX 20mm/s Printing Span 200km Sensor out of paper, cover open Cutting times 2 million times cutting way half cut/ full cut Power supply DC Ports COM LAN Audio jack 24V/2.5A input 3X USB 1X RS232 1X LAN 1X RJ11 for Cash drawer RJ11-4P4C,RS232,+5V、RXD、TXD、 GND RJ45,10/100M 3.5mm standard audio jack, 4 phases with MIC.
Product Summarization Touch Screen Power switch light RJ11 LAN Cover lift Side USB RS232 2 USB Power Adapter Installation of power supply Please connect as per above pic shows.
Install the thermal paper Step1： Take out a roll of paper and lift the cover. Step2：Put the paper inside the groove and pull out the paper to the feeder edge.
Wall mounting Installation Step 1. A suitable flat wall should be required for installing fixture. Install the 4 screws that fixing the bracket on the wall, and install the 4 screws that embedding the equipment on the metal base board Step 2 Put the equipment that installed with 4 Screws into the fixation block.
FCC Caution. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
-Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. This device has been defined as a mobile device whereby a distance of 0.2 m normally can be maintained between the user and the device. Citaq Co.,Ltd Tel: 86-754-88990429 Website: www.citaqpos.
