Cissell MANHD75ST : Owner`s manual : Page 14

Page 14

General Information

GENERAL

INFORMATION

ELECTRICAL

CONNECTIONS

The dryer is so designed that when an operator opens the dryer door, the

basket stops. You can expect fast drying from a laundry dryer. Hot, dry

air is properly and effectively moved through the basket and exhausted

through a lint trap to the atmosphere. The dryer comes equipped with an

inclined, self-cleaning lint screen. In this system, lint accumulates on the

underside of the screen until a blanket approximately 1/4” (7 mm) thick

is formed. This blanket of lint will fall from the screen to the bottom of

the dryer cabinet and should be removed daily, or as required, to prevent

an over accumulation.

Dryers must be electrically groundedDryers must be electrically grounded

Dryers must be electrically grounded by a separate #14 or larger green

wire from the

groundinggrounding

grounding terminal within the service connection box to

a cold water pipe, or through the fourth green wire properly

groundedgrounded

grounded

and connected to the

grounding terminalgrounding terminal

grounding terminal.

In all cases, the groundingIn all cases, the grounding

In all cases, the grounding

method must comply with local electrical code requirements; or in themethod must comply with local electrical code requirements; or in the

method must comply with local electrical code requirements; or in the

absence of local absence of local

absence of local

codes, with the codes, with the

codes, with the

National Electrical Code National Electrical Code

National Electrical Code

,,

,

ANSI/NFPA ANSI/NFPA

ANSI/NFPA

7070

70

or the Canadian Electrical Code, CA C22.1. or the Canadian Electrical Code, CA C22.1.

or the Canadian Electrical Code, CA C22.1.

See wiring diagram furnished with dryer.See wiring diagram furnished with dryer.

See wiring diagram furnished with dryer. Your dryer is completely

wired at the factory and it is only necessary for the electrician to connect

the power leads to the wire connectors within the service connection box

on the rear of the dryer.

Do not change wiring without consultingDo not change wiring without consulting

Do not change wiring without consulting

factory as you may void the factory warranty. Do not connect thefactory as you may void the factory warranty. Do not connect the

factory as you may void the factory warranty. Do not connect the

dryer to any voltage or current other than that specified on the dryerdryer to any voltage or current other than that specified on the dryer

dryer to any voltage or current other than that specified on the dryer

rating plate.rating plate.

rating plate. (Wiring diagram is located on rear wall of dryer.)

«Attention. Lors des opérations d’entretien«Attention. Lors des opérations d’entretien

«Attention. Lors des opérations d’entretien

des commandes, ètiqueter tous les fils avantdes commandes, ètiqueter tous les fils avant

des commandes, ètiqueter tous les fils avant

de les dèconnecter. Toute erreur de câblagede les dèconnecter. Toute erreur de câblage

de les dèconnecter. Toute erreur de câblage

peut être une source de danger et de panne»peut être une source de danger et de panne»

peut être une source de danger et de panne»